Troubleshooting & repair, Drive motor removal and replacement (continued) – Lincoln Electric LN-9 SVM127-A User Manual

Page 125

TROUBLESHOOTING & REPAIR

F-67

LN-9 Wire Feeder

Retur

13. Lift the right side cover assembly and care-

fully lift and slide the motor and wire drive
assembly partially out of the LN-9 box
assembly. See Figure F.27.

14. Using the 1/2" wrench, remove the four bolts

and associated washers holding the glastic
mounting board and mylar insulator to the
gear box assembly.

NOTE:

Four-roll drive units will require the

removal of a 1/2" bolt mounting the reed switch
copper energizer to the glastic plate.

FIGURE F.27 – MOTOR AND WIRE DRIVE REMOVAL

GLASTIC
MOUNTING
BOARD

MYLAR
INSULATOR

MOUNTING
BOLTS (4)

DRIVE MOTOR REMOVAL AND REPLACEMENT

(continued)