Linn Kolektor User Manual
Page 6
iv
CE Declaration of Conformity
Linn Products Ltd declare that this product is in conformance with the Low
Voltage Directive 73/23/EEC and Electromagnetic Compatibility 89/336/
EEC as amended by 92/31/EEC and 93/68/EEC.
The conformity of the designated product with the provisions of Directive
number 73/23/EEC (LVD) is proved by full compliance with the following
standards:
Standard number
Date of issue
Test type
EN60065
1993
General requirements
Marking
Ionizing
Heating under normal conditions
Shock hazards under normal
operating conditions
Insulation requirements
Fault conditions
Mechanical strength
Parts connected to the mains supply
Components
Terminal devices
External flexible cords
Electrical connections and
mechanical fixings
The conformity of the designated product with the provisions of Directive
number 89/336/EEC (EMC) is proved by full compliance with the following
standards:
Standard number
Date of issue
Test type
EN55013
1994
Conducted emissions
EN55013
1994
Absorbed emissions
EN60555-2
1987
Harmonics
EN60555-3
1987
Voltage fluctuations
EN55020
1994
Immunity
FCC notice
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
33
U
unpacking 6
user options 5, 24
Auto-Listen Source 24
Auto-Memory 24
changing 22
Default Display 25
Default Volume 24
Enable IR Control 24
Enable Sleep Mode 24
Enable Unity Gain 25
RC5 Amplifier Address 25
user options
(continued)
resetting 26
Retain User Amplifier
Settings 24
RS232 Command Interface 25
Time-Out Period 25
Volume Control 25
V
VOL- and VOL+ keys 12, 16
voltage selection 6
volume, changing 16
3