Installing a drive in bay 2, Connecting a serial ata drive, Installing – Lenovo 7360 User Manual
Page 26: Drive, Connecting, Serial
Installing
a
drive
in
bay
2
To
install
an
optical
drive
or
an
additional
hard
disk
drive
in
bay
2:
1.
Open
the
computer
cover.
See
2.
Remove
the
metal
shield
from
the
drive
bay
by
using
a
flat-blade
screwdriver
to
gently
pry
it
loose.
3.
If
you
are
installing
a
drive
with
accessible
media,
such
as
an
optical
drive,
remove
the
plastic
panel
in
the
bezel
by
squeezing
the
plastic
tabs
that
secure
the
panel
on
the
inside
of
the
bezel.
Note:
If
you
are
installing
a
3.5-inch
hard
disk
drive
you
must
use
a
Universal
Adapter
Bracket,
5.25
to
3.5-inch.
You
can
obtain
this
bracket
from
a
local
computer
retailer
or
by
contacting
the
Customer
Support
Center.
4.
Slide
the
drive
into
the
bay
until
it
locks
into
position.
5.
Pivot
the
drive
bay
assembly
upward
to
gain
access
to
the
cable
connections
and
connect
the
drive
signal
and
power
cables.
6.
Continue
at
Connecting
a
Serial
ATA
drive
A
serial
optical
drive
or
an
additional
hard
disk
drive
can
be
connected
to
any
available
SATA
connector.
1.
Locate
the
available
SATA
connector
on
the
system
board.
See
2.
Using
the
signal
cable
that
came
with
the
new
drive,
connect
one
end
of
the
signal
cable
to
the
drive
and
the
other
to
the
available
SATA
connector
on
the
system
board.
Figure
11.
Installing
a
drive
in
bay
2
18
ThinkCentre
Hardware
Installation
and
Replacement
Guide