Kenwood Z828MP - Manual (Page 42)

Adjust the bass boost level of the external amplifier using the
main unit.
Display and setting:
"AMP Bass Flat" : Bass boost level is flat. (Default setting)
"AMP Bass +6" : Bass boost level is low (+6dB).
"AMP Bass +12" : Bass boost level is high (+12dB).
As of December 2000, the power amplifiers controllable by the
main unit are as follows:
KAC-X501F/PS501F/X401M/PS401M/X301T/PS301T/X201T/PS201T
NOTE
External Amp Control
You can select the speaker output, either front or rear, for the
TV(AUX) source.
Display and setting:
"Zone 2 Rear" : Output from the rear speaker (Default setting)
"Zone 2 Front" : Output from the front speaker
Not available during the Dual zone system is on.
NOTE
Switching Dual Zone System Output
Toggles on or off the mute control on the built-in amplifier.
Turning on this control enhances the preout quality.
Display and setting:
"Builtin AMP Mute ON" : Built-in Amp Mute is ON.
"Builtin AMP Mute OFF" : Built-in Amp Mute is OFF. (Default
setting)
Built-in Amp Mute Control
When this system is set to on, the System Q factors (Bass
centre frequency, Bass quality factor, Bass extend, Middle
centre frequency, Middle quality factor, and Treble centre
frequency) appear during the audio control mode.
Display and setting:
"System Q ON" : The System Q factors appear and can be
adjusted. (Default setting)
"System Q OFF" : The System Q factors do not appear.
System Q
Menu settings
— 42 —
English
Switch the preout between the rear and non-fading. When you
switch to non-fading, you can adjust the volume separately.
Display and setting:
"SWPRE Rear" : Rear preout (Default setting)
"SWPRE N-Fad" : Non-fading preout
You cannot use the high-pass filter with non-fading preout.
NOTE
Switching preout
You can arrange to have news bulletins interrupt your current
listening source, including other radio stations. When the
News Bulletin function is on, the PTY News Timeout setting
allows you to set the interval during which further news
interruption cannot take place. You can adjust the PTY news
interruption period from 10 to 90 minutes for each journey.
News Bulletin Function with PTY News Timeout
Setting