Kenwood Z828MP - Manual (Page 15)

This function switches the type of information on the display
when the display mode is "Display Type C".
Each time you press the S.A button, the full screen display
changes as follows:
• For display mode selection, see "Switching display mode" (page
12).
• You can switch the Icon/Spectrum analyzer.
See "Icon/Spectrum analyzer Select" in the menu setting (page
41).
NOTE
Spectrum Analyzer 1 + Icon/Spectrum analyzer
Spectrum Analyzer 2 + Icon/Spectrum analyzer
Spectrum Analyzer 3 + Icon/Spectrum analyzer
Spectrum Analyzer 4 + Icon/Spectrum analyzer
Demonstration
Graphic 1
Graphic 2
Switching Full-Screen Display
• For display mode selection, see "Switching display mode" (page
12).
• If the display mode is set to "Display Type B", you can turn on or
turn off the clock.
• The same items cannot be selected for both the upper part and
the lower part.
NOTE
— 15 —
Shut down the audio system temporarily whenever an
incoming call is received.
The function will not work if a cable is not connected to the car
phone.
When the telephone rings:
When a call is received, "CALL" is displayed and all the unit
functions are temporarily interrupted.
Restoring Original Unit Source During Phone Call:
Press the SRC button.
"CALL" disappears from the display, and the volume of the
original source is restored gradually.
Turning TEL Mute Function Off After Phone Call:
Hang the phone up.
"CALL" disappears from the display.
The original source (i.e., the one used before the phone call) is
returned to automatically, and the volume restored gradually.
NOTE
TEL Mute