Kodak V600 - Manual (Page 37)

Safety
33
English
Caution: Never operate your projector without the lamp module or
lamp module door. Doing so may damage the projector.
Caution: Proper ventilation is important. Don’t block ventilation
openings. Never operate this projector in an enclosed area. Do not
place the projector on a tablecloth or other soft covering that may
block the vents. With ceiling installations, use approved mounting
hardware. Do not put the projector near heat ducts, air cleaners,
transformers or other electrical devices. For permanent installations
follow local codes.
Caution: Do not touch the glass portion of the new lamp module
with your hands or allow it to touch other objects as this may damage
it and shorten its operational life.
Caution: Do not drop the lamp module as the glass may shatter.
Battery Safety
• Read and follow all warnings and instructions supplied by
the battery manufacturer.
• Keep batteries away from children.
• Store batteries in their original packaging.
• When inserting batteries, verify that the (+) and (-) terminals
are aligned correctly.
• Replace all batteries of a set at the same time.
• Do not mix new batteries with used ones.
• Do not use batteries of different chemistries, capacities,
brands or sizes together. Leakage could result.
• Do not disassemble, recharge, or short-circuit batteries.
• Do not subject batteries to high temperature or fire.
• Discard used batteries according to all applicable local and
national regulations.
• In the unlikely event of contact with battery electrolyte,
customers in the U.S. can contact the Kodak Information
Center (KIC) at 1-800-242-2424. U.S. customers can also
contact KIC for information regarding electrolyte removal
from KODAK product components. Customers outside the
U.S. can contact their local Kodak Customer Service
representative.
V600UserGuide.book Page 33 Tuesday, March 21, 2000 8:26 AM