Kodak V600 - Manual (Page 33)

Troubleshooting
29
English
Lamp
Problem Cause and Solution
No light is coming from the
lamp.
• Make sure that the power cord is
properly connected to a fully functional
AC electric outlet. The Power light
blinks when the power is connected but
the projector is not turned on. The
Power light is a steady green when the
lamp is running.
• Make sure that the power cord is
properly connected to the projector.
• Make sure that you have removed the
lens cap on the projector lens at the front
of the projector.
• Make sure you have pressed the Power
button and the Power light is a steady
green.
• Check the projector's lamp to make sure
that it is securely connected in the lamp
module.
• Make sure that the lamp module door is
fully closed.
• Make sure that the cable connectors do
not have any bent pins.
• Replace the lamp.
Lamp shuts off. • A minor power surge may cause the
lamp to shut off. Press the Power button
twice to turn off the projector. (The
Power light continues to blink and the
fan continues to run until the projector
cools down.) Wait at least three minutes,
then press the Power button again.
• Replace the lamp module.
V600UserGuide.book Page 29 Tuesday, March 21, 2000 8:26 AM