Kenwood TS-2000 - Manual (Page 3)

ii
MODELS COVERED BY THIS MANUAL
The models listed below are covered by this manual.
TS-2000: HF/ VHF/ UHF All-mode Multi-band
Transceiver
TS-2000X: HF/ VHF/ UHF/ 1.2 GHz All-mode
Multi-band Transceiver
TS-B2000: HF/ VHF/ UHF All-mode Multi-band
Transceiver
As for TS-B2000, refer to the on-line help for
information on how to operate and control the
transceiver. Refer to pages 2, 3, and 13 for the
installation and information on the connectors.
MARKET CODES
K-type: The Americas
E-type: Europe
E2-type: Spain
The market code is shown on the carton box.
Refer to the specifications {page 105} for the
information on available operating frequencies.
NOTICE TO THE USER
One or more of the following statements may be
applicable for this equipment.
FCC WARNING
This equipment generates or uses radio frequency energy.
Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in
the instruction manual. The user could lose the authority to
operate this equipment if an unauthorized change or
modification is made.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED
BY THE FCC
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses and can generate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer for technical assistance.