Kenwood TS-2000 - Manual (Page 24)

16
4 GETTING ACQUAINTED
FILTER
S
1 3 5 7 9 20 40
60dB
PWR
10 25 50
100W%
ALC
57 55 58 42 45 49 48 56
38 40 43 53 46 35 51
39 41 47 54 52 44 36 37 50
#5
Appears while in Satellite mode {page 53}.
#6
Appears while Memory Recall or Memory Scroll is
being used for the sub-receiver {page 59}.
#7
Shows the memory channel number for the sub-
receiver. If you select a channel over 99, a leading
digit (1 or 2) appears (the memory number ranges
from 00 to 299).
#8
Appears when the sub-receiver is selected for the
transmission band.
#9
Appears when the sub-receiver’s functions can be
controlled using the front panel keys.
$0
ATT
Appears when the sub-receiver’s receive attenuator
(approx. 12 dB) is ON {pages 57, 73}.
$1
TNC
Appears when the internal TNC is assigned to the
sub-receiver.
$2 XIT
Appears when Transmit Incremental Tuning of the
main transceiver is ON {page 40}.
$3 PRE
Appears when the receiver pre-amplifier of the sub-
receiver is ON {page 57}.
$4
+ =
“+” or “–” appears, indicating which offset direction is
selected for the sub-receiver. “=” appears when the
–7.6 MHz (430 MHz) or –6.0 MHz (1.2 GHz) offset is
selected (all E-types only) {page 32}.
$5 RIT
Appears when Receive Incremental Tuning of the
main transceiver is ON {page 38}.
$6
DCS
Appears when the DCS (Digital Code Squelch) of the
sub-receiver is ON {page 36}.
$7
[R]
“R” appears when the Reverse function of the sub-
receiver is ON. “[R]” appears when the ASC
(Automatic Simplex Check) of the sub-receiver is
activated {page 34}.
$8
S
Appears when the sub-receiver meter shows the
signal strength level {page 46}.
$9 PWR
Appears when the sub-receiver meter shows the
output power level {page 20}.
%0
Serves as an S-meter to measure and display the
received signal strength for the sub-receiver. It also
displays the relative output power when the sub-band
is selected for the transmission.
%1
C T
“T” appears when the Tone function of the sub-
receiver is ON {page 33}. “C T” appears when the
Continuous Tone Coded Squelch System (CTCSS) of
the sub-receiver is ON {page 35}.
%2
Appears when the DSP Noise Reduction 1 of the sub-
receiver is activated {page 56}.
%3 PKT
Appears when the internal TNC is operating in Packet
mode {page 49}.