Kenwood TS-2000 - Manual (Page 106)

17 INSTALLING OPTIONS
98
MB-430 MOBILE BRACKET
When installing the MB-430, attach the supplied
plastic spacers (G11-2698-XX) to the transceiver in
advance. This is necessary to protect the
TS-2000(X)/ TS-B2000 transceiver from scratches.
Once the bracket is installed onto the vehicle,
prepare the transceiver by loosely screwing in the
rear screws. Hook those screws onto the rear guide
rail of the mounting bracket then adjust the
transceiver to your desired angle before tightening
the screws. Insert and tighten the front screws to
secure the transceiver in place.
To remove the transceiver from the bracket, first
remove the front screws, then loosen the rear screws
slightly and pull the transceiver forward to unlatch it
from the bracket.
Do not install the transceiver so that it is vertically on its side.
RC-2000 REMOTE PANEL
Plug the modular cable from the RC-2000 into the
PANEL connector on the TS-2000(X)/ TS-B2000 rear
panel. Access Menu Nos. 58 ~ 60 to adjust the panel
configuration if necessary.
TS-2000/ TS-2000X
TS-B2000
Rear screw
Rear screw
Front screw
Front screw
Make sure the tab faces out
G11-2698-XX