Error messages on the message window, Error messages on the message window 75 – Konica Minolta Magicolor 2590 MF User Manual
Page 81
Error Messages on the Message Window
75
Error Messages on the Message Window
Error message
Cause
Solution
LINE PROBLEM
(Flashing alter-
nately)
CHECK LINE
The telephone dialing
system or telephone
wiring system is not
set correctly.
The telephone cable
is not attached cor-
rectly.
Check the telephone dialing
system or telephone wiring
system and use the appropri-
ate configuration menu to
make the correct settings.
Correctly connect the tele-
phone cable.
*COMM.ERROR*
(####)
Communication is not
possible because of
some problem in the
machine.
Communication is not
possible because of a
problem with the
recipient/caller’s fax
machine.
Check the transmission results.
*REDIAL ALL FAILED* All redial attempts failed
because either the recip-
ient’s line is busy or
there was no answer.
Check the condition of the recipi-
ent’s line, and then try sending
the fax again.
*MEM.FULL/TX CAN-
CEL*
While sending a fax, the
size of the data for the
scanned image has
exceeded the capacity of
memory.
Retrieve all received faxes stored
in memory.
Send the fax by direct transmis-
sion.
To print an error report, press the
Cancel/C key while an error
message is displayed.
*MEM.FULL/RX CAN-
CEL*
While receiving a fax,
the size of the data for
the scanned image has
exceeded the capacity of
memory.
Retrieve all received faxes stored
in memory.
To print an error report, press the
Cancel/C key while an error
message is displayed.
HANG UP THE
PHONE
The receiver of the con-
nected telephone is
lifted.
Replace the receiver of the con-
nected telephone on the hook.