Konica Minolta Magicolor 2590 MF - Manual (Page 37)

Basic Fax Operation 31
– Using the Speed Dial function
– Using the Phone Book function
– Using the Redial/Pause key
"
For details on specifying the recipient, refer to “Specifying a Recipient”
on page 34. For details on using the Redial/Pause key, refer to “Using
the Redial Function” on page 38.
"
A transmission can also be sent to multiple recipients with the Broad-
cast function. For details on sending a broadcast transmission, refer to
“Sending a Fax to Multiple Recipients (Broadcast Transmission)” on
page 38.
7
Press the Start key.
The document is scanned, and then the fax is sent.
"
To stop the transmission, press the Stop/Reset key. A message
appears, requesting confirmation to cancel the setting. Select “Yes”,
and then press the Menu Select key.
"
If the fax could not be sent (for example, because the line was busy),
the automatic redial function will try sending the transmission again.
If the fax could not be sent with the automatic redial function, a TX
Result Report can be printed. For details, refer to “TX RESULT
REPORT” on page 67.
"
If you want to cancel a scanned document queued for transmission or
a fax waiting to be redialed, select “CANCEL RESERV.” from the
Function menu. For details, refer to “Canceling (Deleting) a Document
Queued in Memory for Transmission” on page 42.
"
Since a document with multiple pages is saved in memory while it is
being sent, the document is scanned at high speed. A maximum of
512 pages can be stored in memory. (If a high resolution is selected
while scanning detailed documents, 512 pages may not be stored in
memory.) If memory is nearly full, scanning of the document is
stopped and a message appears, allowing you to select whether to
start the transmission or cancel that transmission job. If the selection
is made to cancel the job, the pages of the document that have been
scanned for that job are deleted. If the selection is made to begin the
transmission, scanning of the document is stopped and transmission
begins. After the scanned pages have been sent, scanning of the doc-
ument starts again.