Installation – Kidde PI2000CA User Manual
Page 12
Installation
11
• Pull the AC Quick-Connect wire harness through the
center hole in the mounting bracket and secure the
bracket, making sure that the mounting screws are
positioned in the small ends of the keyholes before
tightening.
• Plug the AC Quick-Connect wire harness into the back
of the alarm (Image 5), making sure that the locks on
the connector snap into place. Then push the excess
wire back into the electrical box through the hole in the
center of the mounting plate.
• Install the alarm on the mounting plate and rotate the
alarm in the direction of the “ON” arrow on the cover
until the alarm ratchets into place (Image 4D). This
ratcheting function allows for aesthetic alignment. Note:
The alarm will attach to the mounting plate in 4
positions (every 90°).
• Turn on the AC power. The green AC Power On indicator
should be lit when the alarm is operating from AC power.
IMAGE 5
ATTACHING THE AC QUICK-CONNECT WIRE HARNESS
- 3SF23/9HI (10 pages)
- 0976 (14 pages)
- 1235E (2 pages)
- 1285 (7 pages)
- 440376 (7 pages)
- KN-COB-DP-LS (2 pages)
- KN-COP-DP-LS (18 pages)
- 468093 (2 pages)
- SM120X (1 page)
- Smoke Alarm 914 (23 pages)
- 440379 (6 pages)
- 1275E (2 pages)
- KN-COP-DP-LS (2 pages)
- SL177i (2 pages)
- PE9CA (12 pages)
- 440375 (6 pages)
- 1276CA (14 pages)
- I9080 (18 pages)
- I9080 (10 pages)
- RF-SND (11 pages)
- Smoke Alarm (2 pages)
- KN-COPP-B-LS (2 pages)
- RF-SM-ACDC User Guide (22 pages)
- KN-COSM-BA (30 pages)
- KN-COSM-B (18 pages)
- i12060 (17 pages)
- i12060A (18 pages)
- PI 2000 (7 pages)
- SIRIUS TM0109 (4 pages)
- PI9000 (2 pages)
- 914 (2 pages)
- HD135F (2 pages)
- KN-COB-IC (12 pages)
- KN-COB-IC (23 pages)
- 0910 (2 pages)
- Strobe Light SL177 (26 pages)
- 1296 (2 pages)
- TM0098 (4 pages)
- 976 (2 pages)
- KN-COB-IC (25 pages)
- KN-COSMXTR-B (33 pages)
- SMOKE AND CARBON MONOXIDE ALARM (106 pages)
- I9070 (17 pages)
- 0915 (6 pages)
- 9 Volt Battery Operated Photoelectric/Ionization Smoke Alarm PI9000 (26 pages)