Kenwood DNX7180 - Manual (Page 26)

26
Quick Start Guide
NOTE
• Install the microphone as far as possible
from the cell-phone.
Removing Procedure
Removing the hard rubber
frame (escutcheon)
1) Engage the catch pins on the
removal tool (accessory4) and
remove the two locks on the
lower level.
Lower the frame and pull it
forward as shown in the figure.
4
Lock
Catch
NOTE
• The frame can be removed from the top
side in the same manner.
2) When the lower level is removed,
remove the upper two locations.
Removing the unit
1) Remove the hard rubber frame by
referring to step 1 in “Removing
the hard rubber frame”.
2) Insert the two removal tools
(accessory4) deeply into the slots
on each side, as shown.
4
3) Lower the removal tool toward
the bottom, and pull out the unit
halfway while pressing towards
the inside.
NOTE
• Be careful to avoid injury from the catch
pins on the removal tool.
4) Pull the unit all the way out with
your hands, being careful not to
drop it.
DNX7_QSG_K.indd 26 10/12/16 16:42