Kenwood KXF-W4010 - Manual (Page 7)

7
CT-2050/203/KXF-W6010/W4010 (En/M)
System connections
SWITCHING FROM [SL16] TO [XS8]
You can easily change the system control mode with the following operation. Do this operation after completing all connections.
Switching to [XS8]: Hold down the 1 (rewind) key on Deck B and switch the POWER key from OFF to ON. 8
Switching back to [SL16]: Hold down the ¡ (fast forward) key on Deck B and switch the POWER key from OFF to ON. 8
÷ This operation will not affect items stored in the memory.
ABOUT THE SYSTEM CONTROL CONNECTIONS
Connecting system control cords after connecting a KENWOOD audio component system lets you take advantage of convenient system
control operations.
There are two KENWOOD system control modes. Make connections according to the groups of terminal symbols shown below.
[XS8] Mode : lets you combine F, f and ƒ terminals
[SL16] Mode : for terminals only
This unit is compatible with both [XS8] and [SL16] modes. It comes from the factory set to the [SL16] mode. To
switch to the [XS8] mode, follow the instructions in “SWITCHING FROM [SL16] TO [XS8]” below.
1. [SL16] equipment cannot be combined with [XR], [XS], and [XS8] equipment for system operations. If your equipment consists of this kind
of combination, please do not connect any system control cords. Even without system control cords, normal operations can be carried out
without affecting performance.
2. If your amplifier or receiver does not have a system control terminal, do not connect any system control cords to the system control terminals
on the other components.
3. Do not connect system control cords to any components other than those specified by KENWOOD. It may cause a malfunction and damage
your equipment.
4. Be sure the system control plugs are inserted all the way in to the system control terminals.
Notes Notes
ABOUT THE SYSTEM CONTROL OPERATIONS
Remote Control
Lets you operate this unit with the system remote supplied with the amplifier or receiver.
Automatic Operation (except [XR] equipment)
Automatically switches the input selector on the amplifier or receiver when you start playback from this unit.
Synchronized Recording (except [XR] equipment)
Lets you synchronize recording with the start of playback when recording from CD, MD, LD, or analog discs. Also, the simple CCRS
operation lets you make great recordings from CD.