Kenwood KXF-W4010 - Manual (Page 10)

CT-2050/203/KXF-W6010/W4010 (En/M)
10
Playback (recording) preparation
2
Select the tape transport direction.
1
Load a cassette tape in deck A or B.
Preparation for playback (recording)
Before playback (recording)
Normal position TYPE
High position TYPE
Metal position (playback only) TYPE
Deck B: Play-
b a c k / r e c o r d i n g
available.
B A
To play (record)
tape side A.
÷ Be sure to remove tape slack before insertion.
÷ The type of tape, that is, the Normal, High position or Metal position
(playback only) is selected automatically.
÷ This unit cannot record sound on a Metal tape.
÷ Be sure to close the cassette holder securely by pushing it.
Feed the tape section which cannot be
played or recorded onto in the forward
direction.
÷ Select the Dolby NR mode according to the tape recording status.
Deck A:
Playback only. (CT-203/
KXF-W4010 only)
Playback/recording avail-
able. (CT-2050/KXF-W6010
only)
To play (record)
tape side B.
The 2 and 3 indicators show the direction the tape is transported
during recording or playback. The direction used when the tape is
last stopped is held in memory even after this unit has been turned
OFF, and the tape transport starts in the indicated direction when
the unit is started automatically by a timer, etc. To change the tape
transport direction, press the play key for the opposite direction and
immediately press the stop (
7) key.
Tape transport direction indicators
Deck B direction indicators. Deck A direction indicators.
Each press switches the indication.
1 “ [” :Double-side playback (recording) which stops tape
stops after having played (or recorded) both sides.
2 “ ”” :Playback is endless, but recording stops after having
recorded both sides.
3 “ “” :One-way playback (recording) which stops tape af-
ter having played (or recorded) a single side.
Each press switches the indication.
1 DOLBY NR “OFF” (extinguished): Dolby NR is not used.
2 DOLBY NR “B”: Noise reduction of the ordinary type.
3 DOLBY NR “C”: Noise reduction with higher performance.
: Keys and control used in the operations described on this page.
0
REV.MODE
DOLBY NR
2 3 7
2 3 7
1
Press the play ( 2 or 3) key.
3
Determine the playback (recording) condition.
2
Press the stop ( 7) key.
1
Select the playback (recording) mode.
2 Select the Dolby NR mode.
1 Press the eject ( 0) key.
2
Insert a tape and close the cassette holder.
POWER
- ON – OFF
TIMER
REC OFF PLAY
2 Set the POWER switch to ON.
1
Set the TIMER switch to OFF.