Kenwood KXF-W4010 - Manual (Page 17)

17
CT-2050/203/KXF-W6010/W4010 (En/M)
How to record (CT-203/KXF-W4010; Deck B only)
÷ To adjust the bias level, play back the recorded sound and adjust to the
suitable level.Repeat if necessary.
÷ The bias can be adjusted to a value of ±3.
Bias level adjustment (Deck B of the CT-2050/KXF-W6010 only)
÷ Recording will start.
÷ The deck enters the stop mode automatically when the tape has
been recorded till the end.
The MODE key can be used to adjust the bias level.
lights up
Press once.
4
Start recording.
1 Press the REC/ARM ( ¶) key.
2 Play the music source from the begin-
ning.
¶
REC/ARM
1 Press the MODE key and select the "BIAS"
mode.
2 Adjust the bias level.
MODE
REC LEVEL/BAL.
/BIAS
∞
MAX/R
∞
MIN/L
The high frequency
decreases. The high frequency
increases.
How to use the MPX FILTER key
Depending on the tuner, a recorded FM broadcast may
produce a “beat” sound. In this case, press the MPX FILTER
key before recording. To cancel, press the MPX FILTER key
again.
MPX FILTER
lights up
CT-2050/KXF-W6010
CT-203/KXF-W4010
Use this function when recording a radio (FM) broadcasts.
Each press of the MODE key changes the setting.
1 “LEVEL” lights up: Recording level setting mode
2 “BAL.” lights up: Recording balance setting mode
3 “BIAS” lights up: Recording bias setting mode (Deck B of the
CT-2050/KXF-W6010 only)
4 “LEVEL”,“BAL.”,and “BIAS”go off: Counter display mode