Kenwood DDX8046BT - Manual (Page 105)

DDX series DDX896/ DDX8046BT English 105
Next page 3
Remote Controller
This unit can be operated using the Remote Controller supplied with this unit.
Battery installation Battery installation
Use two "AAA"/"R03"-size batteries.
Insert the batteries with the + and – poles
aligned properly, following the illustration
inside the case.
⁄
• If the Remote Controller operates only over
shorter distances or does not operate at all, it is
possible that the batteries are depleted. In such
instances, replace the both batteries with new
ones.
Remote Controller mode switch Remote Controller mode switch
The functions operated from the remote
controller differ depending on the position
of the mode switch.
DVD
T V
NAV
AUD
U
U
U
U
AUD mode
Switch to this mode when controlling a
selected source or tuner source, etc.
DVD mode
Switch to this mode when playing DVDs or
CDs etc. with the player integrated in this
unit.
¤
CAUTION
• Put the Remote Controller in a place where it will not move during braking or other operations. A
dangerous situation could result, if the Remote Controller falls down and gets wedged under the pedals
while driving.
• Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat generation
may result.
• Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause
the battery to leak fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately rinse
with water and consult a physician.
• Place the battery out of reach of children. In the unlikely event that a child swallows the battery,
immediately consult a physician.