Kenwood Sovereign VR-5080 - Manual (Page 79)

71
T
roubleshooting
Sound
Sound
I don’t hear any sound at all
Check that:
• The volume is set at the proper level. See “Adjusting the Volume” on
page 10 of this manual.
• Mute is OFF. If the MUTE indicator on the front of the receiver is
blinking, MUTE is ON. See “Muting Sound” on page 16 of this
manual.
• The proper input (e.g., CD player, Tuner, etc.) has been selected on
the Remote Control unit. See “How Do I Operate Devices?” on page 36
of this manual.
• The proper zone has been selected. See “How Do I Switch Control
Modes?” on page 54 of this manual.
• The CD2/TAPE2 MONITOR input has not been selected. (If it has,
the CD2/TAPE2 MONITOR indicator on the receiver’s front panel
will be lit). See “What’s on the Front Panel of Your Kenwood Audio -
Video Receiver?” on page 2 of this manual.
• The input mode matches the input signal (e.g., analog vs. digital) that
has been set. See “Switching Input Modes” on page 23 of this manual.
• The correct Input Mode (e.g., Full Auto) has been set for the digital
input. See “Input Modes” on page 22.
• The correct speakers have been activated. See “Turning the Speakers
On” on page 9 of this manual.
Audio is not output only when a 96k fs compatible disc is played.
•
The optical cable may be bent. Use a new optical cable.
• Check that the optical cable connector is connected properly.
• Certain DVD player models inhibit digital output. Use analog cables
with such a DVD player.
The 96k fs indicator does not light while a 96k fs compatible disc is
being played.
• The indicator will not light unless the DVD player is properly set.