KVH Industries TracVision M5 - Manual (Page 27)

28
To connect three or more receivers, follow these
steps to install an active (powered) multiswitch
between the antenna and the receivers.
NOTE: You can purchase an active multiswitch,
Channel Master model 6314IFD, from KVH (order
part #19-0123).
1. Connect the RF1 cable from the antenna to
the “RHCP +13V” jack on the multiswitch
(see Figure 46).
2. Connect the RF2 cable from the antenna to
the “LHCP +18V” jack on the multiswitch.
3. Connect the receivers to the individual
outputs of the multiswitch.
4. Terminate any unused multiswitch outputs
with 75 ohm DC blocks (Channel Master
#7184, Radio Shack #15-1259, or equivalent).
Only antennas equipped with a circular dual
LNB can support more than two receivers.
Antennas equipped with a linear LNB
support only two receivers.
IMPORTANT!
+ –
HDTV CONTROL ANTENNA UNIT RF PORT TONE DETECT FUSE POWER IN + / –
MCP
RF2
RF1
LHCP
+18V RHCP
+13V
Switchplate
Antenna
Receiver #2
SATELLITE IN OUT TO TV
TV ANT/CABLE IN
AUDIO VIDEO S-VIDEO PHONE JACK
R L
SATELLITE IN
Receiver #1
SATELLITE IN OUT TO TV
TV ANT/CABLE IN
AUDIO VIDEO S-VIDEO PHONE JACK
R L
SATELLITE IN
Receiver #3
SATELLITE IN OUT TO TV
TV ANT/CABLE IN
AUDIO VIDEO S-VIDEO PHONE JACK
R L
SATELLITE IN
Receiver #4
SATELLITE IN OUT TO TV
TV ANT/CABLE IN
AUDIO VIDEO S-VIDEO PHONE JACK
R L
SATELLITE IN
Multiswitch DC Power
Data
Power
Figure 46: Multiswitch Wiring - Antenna with Circular Dual LNB
Be sure the multiswitch is properly grounded.
With the multiswitch grounded, you do not
need to ground the individual receivers.
IMPORTANT!
(DIRECTV only) Multiswitches block a
receiver’s 22 KHz tone that the antenna needs
to switch satellites automatically. Therefore,
the customer will need to manually switch
satellites using the buttons on the MCU.
IMPORTANT!
Wiring 3+ Receivers
(Circular only)
B
Appendix