Kodak SD-63HK - Manual (Page 11)

11
Slide the battery compartment cover in the
direction of the arrow.
Install two “R03” batteries (supplied), paying
attention to the polarity diagram in the battery
compartment.
Replace the compartment cover.
Notes on batteries
Improper use of batteries may cause battery leakage and
corrosion. To operate the remote control correctly, follow the
instructions below.
• Do not insert batteries into the remote control in the wrong
direction.
• Do not charge, heat, open, or short-circuit the batteries. Do
not throw batteries into a fire.
• Do not leave dead or exhausted batteries in the remote
control.
• Do not use different types of batteries together, or mix old
and new batteries.
• If you do not use the remote control for a long period of time,
remove the batteries to avoid possible damage from battery
corrosion.
• If the remote control does not function correctly or if the
operating range becomes reduced, replace all batteries with
new ones.
• If battery leakage occurs, wipe the battery liquid from the
battery compartment, then insert new batteries.
1 Point the remote control at the remote
sensor and press the buttons.
Distance: About 7 m from the front of the remote
sensor
Angle: About 30
°
in each direction of the front of
the remote sensor
* Do not expose the remote sensor of the unit to a
strong light source such as direct sunlight or other
illumination. If you do so, you may not be able to
operate the unit via the remote control.
Notes on the remote control
• Direct the remote control at the remote sensor of the unit.
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or
humid place.
• Do not spill water or put anything wet on the remote
control.
• Do not open the remote control.
• When using the remote control, press the button at
intervals of about 1 second to ensure the correct mode of
operation.
2
3
Within about 7 m
Operating with the remote control Loading batteries
2D20401A P08-15 26/9/03, 6:01 PM 11