Kenwood NEXEDGE NX-700H - Manual (Page 26)

20
DTMF (DUAL TONE MULTI FREQUENCY) CALLS
Note: DTMF calls can be made only in analog Operation.
m
Aking A
dTmF c
All
■
Manual Dialing (Microphone Keypad Only)
1 Press and hold the microphone PTT switch.
2 Enter the desired digits using the microphone keypad.
• The corresponding DTMF tones sound each time you press a key.
• If you release the microphone PTT switch, transmit mode will end even if the
complete number has not been sent.
■
Keypad Auto PTT (Microphone Keypad Only)
If your dealer has activated the Keypad Auto PTT function, simply press the
microphone keys to make the call.
• The DTMF code will be sent automatically when you press a key.
■ Store & Send
1 Press the key programmed as Autodial.
2 Enter the desired digits using the microphone keypad.
• The digits appear on the display as you enter them.
• Alternatively, you can enter digits by using
the / keys {page 4}.
• You can enter up to 30 digits before transmitting.
3 After entering the complete number, press the microphone PTT switch or
the key to transmit.
Note: If you switch the power OFF before transmitting the number, the number will be cleared.
A
uTodiAl
Autodial allows you to quickly call DTMF numbers that have been programmed
onto your transceiver.
1 Press the key programmed as Autodial, or access the Autodial function
through the Menu {page 2}.
• The first entry in the Autodial list appears on the display.
2 Press the / keys or enter the appropriate DTMF number (0 ~ 32) to select
your desired Autodial list number.
• The stored entry appears on the display.
3 Press the microphone PTT switch to make the call.
S
Tun
c
ode
This function is used when a transceiver is stolen or lost. When the transceiver
receives a call containing a stun code, either transmit mode will be disabled,
or both receive mode and transmit mode will be disabled. The stun code is
cancelled when the transceiver receives a call with a revive code.