Kenwood NEXEDGE NX-700H - Manual (Page 17)

r
eceiving
1 Select the desired zone and channel using the Zone Up/ Zone Down or
CH/GID Up/ CH/GID Down keys. (If the Scan function has been programmed,
you can switch it on or off as desired.)
2 When you hear a caller’s voice, readjust the volume as necessary.
• If signaling has been programmed on the selected channel, you will hear a call only
if the signaling tone matches the tone set up on your transceiver.
Note: Signaling allows your transceiver to code your calls. This will prevent you from listening
to unwanted calls. It does not make calls private, it only prevents them from being heard by
transceivers set with a different signaling code. Refer to “SIGNALING” on page 24 for details.
■
Receiving Group Calls (Digital)
When you receive a group call on a Conventional channel and the received group
ID matches the ID set up on your transceiver, you can hear the caller’s voice.
When you receive a group call on a Trunking channel, the transceiver
automatically switches to the communications channel to receive the call.
• Readjust the volume as necessary.
■ Receiving Individual Calls (Digital)
When you receive an individual call on a Conventional channel, a ringing tone
will sound and the display will show the caller’s ID. To respond to the call,
press and hold the microphone PTT switch and speak into the transceiver as
you would during a normal transmission.
When you receive an individual call on a Trunking channel, a ringing tone will
sound and the caller’s ID will appear on the display. After receiving the call,
you can respond to the call by pressing and holding the microphone PTT switch
and speaking into the microphone as you would during a normal transmission.