Kenwood NEXEDGE NX-700H - Manual (Page 11)

5
!1 key
Press to activate its programmable function {page 7}. The default setting is
Zone Down.
!2 key
Press to activate its programmable function {page 7}. The default setting is
Zone Up.
!3 key
Press to activate its programmable function {page 7}. The default setting is
None (no function).
!4 Speaker
Internal speaker
!5 PTT (Push-to-Talk) switch
Press and hold this switch then, speak into the microphone to call a station.
d
iSplAy
Indicator Description
Appears when the Monitor or Squelch Off function is
activated.
Blinks when signaling of an incoming call matches the
Optional Signaling set up on your transceiver.
Appears when the current zone (left icon) or CH/GID (right
icon) is added to the scanning sequence.
Appears when you are using Scan mode. Blinks while
paused at a channel.
Appears when there is a message stored in the transceiver
memory. Blinks when a new message has arrived.
Appears when the current channel is programmed as a
Priority channel. “ ” represents Priority channel . “ ”
represents Priority channel 2. “ ” represents Priority
channels and 2.
Appears when the Operator Selectable Tone (OST) function
is activated.
Appears when the call is a Telephone ID call. Blinks when
Auto Telephone Search is activated. (The location of this
icon is the same as the OST icon.)
Appears when the Talk Around function is activated.