Listening to the radio – Kenwood KDC-208U User Manual

Page 7

ENGLISH

Hold for about 2 seconds to memorize the current station.

Press briefly to recall memorized station.

Adjust [SETTINGS] mode settings

While listening to the radio...
1 Press the volume knob to enter [FUNCTION] mode.
2 Turn the volume knob to select [SETTINGS], then press to enter.
3 Turn the volume knob to make a selection, then press to confirm.
See table below for selection.
4 Hold

to finish the procedure.

Item

Selectable setting (Preset: *)

SEEK MODE

Selects the tuning mode for

4 / ¢ buttons.

AUTO1 *: Automatically search for a station. ; AUTO2: Search in the order of the stations in the preset
memory. ; MANUAL: Manually search for a station.

AUTO MEMORY YES: Automatically starts memorizing 6 stations with good reception. ; NO *:

Cancels (automatic

memorizing is not activated). (Selectable only if [NORM] is selected for [PRESET TYPE].) (page 6)

MONO SET

ON: Improve the FM reception (but the stereo effect may be lost). ; OFF *: Cancels (stereo effect resumes).

Using the remote controller (RC-405)
FM+ / AM–

: Selects band.

4 / ¢ ( + ) : Selects station.
1 – 6

: Selects preset station.

Listening to the radio

Item

Selectable setting (Preset: *)

SWITCH PRE REAR */ SUB-W: Selects whether rear speakers or a subwoofer are connected to the line out terminals on the

rear of the unit (through an external amplifier).

SP SELECT

OFF */ 5/4/ 6 × 9/6/ OEM: Selects the speaker size for optimum performance.

F/W UP xx.xx YES: Starts upgrading the firmware. ; NO *:

Cancels (upgrading is not activated).

For details on how to update the firmware, see: www.kenwood.com/cs/ce/

1 Press SRC to select “TUNER.”
2 Press BAND repeatedly to select a band (FM1/ FM2/ FM3/ AM).
3 Press

4 / ¢ to search for a station.

EN02-15_KDC-248U[K]5.indd 7

8/24/10 5:11:23 PM