Kenwood KDC-MP8017 - Manual (Page 39)

— 39 —
If the following situations, consult your nearest service center:
• Even though the disc changer is connected, the Disc Changer Mode is not on, with "AUX" showing in the display during the Changer Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the AUX Mode is
entered when switching modes.
Troubleshooting Guide
Cannot play CD-R or CD-RW Finalization processing is not being conducted for CD-
R/CD-RW. Conduct finalization processing with CD recorder.
A non-compatible CD changer is being used to play the
CD-R/CD-RW. Use a CD changer compatible with CD-R/CD-RW to play.
CD/MP3/External disc control mode
The computer chip in the unit is not functioning normally. Press the reset button on the unit (see p. 5).
The disc control mode cannot
be selected. No wire has been connected to the disc changer input
terminal on the unit. Connect the wire to the disc changer input terminal on
the unit.
The specified disc does not
play, but another one plays
instead. The specified CD is quite dirty. Clean the CD.
The CD is upside-down. Load the CD with the labeled side up.
The disc is loaded in a different slot from that specified. Eject the disc magazine and check the number for the
specified disc.
The disc is severely scratched. Try another disc instead.
The sound skips. Something is touching the disc changer. Remove whatever is touching it.
The CD is scratched or dirty. If skipping happens at the same place when the car is
stopped, something with the CD is wrong. Clean the CD.
The display shows that the
changer is being played, but no
sound can be heard.
SOLUTION POSSIBLE CAUSE PROBLEM
The specified track will not
play. Random play or magazine random play has been
selected. Turn off random play or magazine random play.
Track repeat, disc repeat, track
scan, random play, and
magazine random play start by
themselves. The setting is not cancelled. The settings for these functions remain on until the
setting to off or the disc ejected, even if the power is
turned off or the source changed.
KDC-MP8017_U.S 00.12.26 0:59 PM Page 39