Kenwood DNX710EX - Manual (Page 83)

English 83
4 Quit memorization/recalling of settings
EXT SW Setup
Setting up power specification of the external
device for which the power is controlled from
this unit.
1 Display the EXT SW SETUP screen
Touch [EXT SW SETUP] in the SETUP Menu
(page 66).
2 Perform EXT SW Setup
Setting EXT SW Control 1 (EXT SW1)
1
2
3
4
1 Sets the name of the external device. See
(page 56) for information
on how to enter the name.
2 Sets the power signal output mode.
Pulse: Generates a single power signal
pulse.
Level: Continues output of high power
signal.
Sets to turn output on/off each time
the button on the EXT SW Control
screen is pressed.
3 Sets the Pulse signal output time.
Outputs 500ms when "1" is set. Increases
by 200ms with each step. Up to 100 steps
can be set.
Setting EXT SW Control 2 (EXT SW2)
1
2
3
4
The setup method is the same as "EXT SW1".