Kenwood VR-5090 - Manual (Page 38)

30
Using R
eceiv
er
How Do I Adjust the Surround Modes?
6. Press the SOUND button to “Center Width 0” (or “1” to “7” etc.) is
displayed on Remote Control unit.
7. Press the LCD cursor up/down ( / ) button on Remote Control
unit to select “Center Width 1” (or “0”, “2” to “7”), then press the
Home button.
The Center Width is not displayed if the Center speaker is set to "Off" in
the speaker setup (see "Setting Up Speakers" on page 36 of the Connec-
tions and Setup Guide).
Operation on the receiver:
1 Press the LISTEN MODE button inside the door repeatedly until the
PL II : Music mode to be set is displayed.
2. Press the SOUND button repeatedly until to display “PANORAMA
OFF” (or “ON”).
3. Press the MULTI CONTROL (
%/fi) button to select “PANORAMA
ON” (or “OFF”).
4. Press the SOUND button to display “DIMENSION 0” (or “F-1” etc.).
5. Press the MULTI CONTROL (
%/fi) button to select “DIMENSION F-
1” (or “F-2”, “F-3”, “R-1” to “R-3”).
6. Press the SOUND button to display “CENTER WIDTH 0” (or “1” to
“7” etc.).
7. Press the MULTI CONTROL (
%/fi) button to select “CENTER WIDTH
1” (or “0”, “2” to “7”).
8. Press the SOUND button repeatedly until “SOUND FIXED” is dis-
played.