Kenwood VR-5090 - Manual (Page 16)

8
Using R
eceiv
er
Chapter Two: Controlling the Receiver
Remote Control unit provided with the receiver is a bi-directional Re-
mote Control unit, which enables remote control while checking the in-
formation shown on the LCD display. The operations of connected de-
vices can also be controlled from Remote Control unit.
Before first time using the receiver or after having changed or added the
connected devices, please be sure to read the separate booklet entitled
“Connection and Setup Guide”.
The present manual describes the operation procedures in normal use.
This chapter is composed of the following sections.
How Do I Adjust the Sound? page 9
How Do I Adjust the Surround Modes? page 17
Selecting the Inputs page 35
How Do I Operate Devices? page 36
How Do I Adjust the LCD Display? page 50
Executing Several Operations at Once (Macro function) page 52
The Remote Control unit transmits an infrared signal in addition to an
RF signal. When operation by means of the RF signal is not possible be-
cause of the radio wave conditions, aim the Remote Control unit towards
the receiver and use it as an infrared remote control.
For operation of other identified devices or with an external IR receiver,
aim the Remote Control unit towards the respective unit and use it as an
infrared remote control.
Do not block the remote control IR transmitter on the Receiver or the
transceiver part of the Remote Control unit. A momentary error is pos-
sible when the signal is interrupted even momentarily during transmis-
sion and reception (for example by a person passing through the beam).
In such a case, the most recent information will be displayed when CON-
FIRM/SHIFT button on the Remote Control unit is pressed. Sometime it
may be necessary to reenter the interrupted command again.