Kenwood KRC-435 User Manual

Page 26

English

— 26 —

■ Removing the hard rubber frame

When the lower level is removed, remove the upper two
locations.

The frame can be removed from the top side in the same manner.

Catch

Lock

Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull it forward as shown in the figure.

Accessory2
Removal tool

Screw (M4X8)
(commercially
available)

■ Removing the Unit

Lower the removal tool
toward the bottom, and pull
out the unit halfway while
pressing towards the inside.

Be careful to avoid injury from
the catch pins on the removal
tool.

Pull the unit all the way out
with your hands, being
careful not to drop it.

Refer to the section “Removing the hard rubber frame” and then
remove the hard rubber frame.

Remove the screw (M4

× 8) on the back panel.

Insert the two removal tools deeply into the slots on each side,
as shown.

Installation

KRC435_U.S_r3 01.11.27 7:18 PM Page 26