Kenmore 415.162090 - Manual (Page 17)

WARNING
If “growing” bubbles appear do not use or move the LP tank.
Contact an LP gas supplier or your fire department!
463350505 • 17
LP Tank Exchange
LP Tank Leak Test
• Many retailers that sell grills offer you the option of replacing
your empty LP tank through an exchange service. Use only
those reputable exchange companies that inspect, precision fill,
test and certify their cylinders.
Always keep new and exchanged LP tanks in upright position
during use, transit or storage.
•
Leak test must be repeated each time LP tank is exchanged or
refilled.
Do not smoke during leak test.
Do not use an open flame to check for gas leaks.
Grill must be leak tested outdoors in a well-ventilated area,
away from ignition sources such as gas fired or electrical
appliances. During leak test, keep grill away from open flames
or sparks.
• Use a clean paintbrush and a 50/50 mild soap and water
solution.
Exchange your tank only for
an OPD safety feature-equipped tank as described in the
"LP Tank" section of this manual.
•
Leak test new and exchanged LP tanks BEFORE
connecting to grill.
For your safety
•
•
•
•
s Do not use household cleaning agents. Damage to gas
train components can result.
Brush soapy solution onto areas indicated by arrows
in figure below. Leaks are indicated by growing bubbles.
Connecting Regulator To The LP Tank
1.
2.
3.
full stop
4.
LP tank must be properly secured onto grill. (Refer to
assembly section.)
Turn all control knobs to the OFF position.
Turn LP tank OFF by turning OPD hand wheel clockwise to a
.
Remove the protective cap from LP tank valve. Always use
cap and strap supplied with valve.
Safety Relief Valve
Nipple has to be centered
into the LP tank valve.
OPD Hand Wheel
Type 1 outlet with
thread on outside
Off
Clockwise
Do not use a POL transport plug
(plastic part with external threads)!
It will defeat the safety feature of
the valve.
5. Hold regulator and insert nipple into LP
tank valve. Hand-tighten the coupling
nut, holding regulator in a straight line
with LP tank valve so as not to cross-
thread the connection.
Strap and Cap