Kenwood KDC-V7090R EN - Manual (Page 8)

Switching Modes:
Each time you press the SRC button, the mode switches as
follows:
Switching Modes
You can help prevent theft of the unit by reversing the
faceplate so that the control panel cannot be seen, hiding the
unit, and shutting off the audio.
Power ON/OFF:
When you turn your vehicle’s ignition on, the unit’s power will
also turn on, with the faceplate reversing to show the control
panel.
When you turn your vehicle's ignition off, the faceplate will
reverse to hide the control panel after a period of time which
you have set in the "Time setting for removing the faceplate" in
the menu. The unit's power will turn off.
Alternatively, you can remove the faceplate during that period.
For details, refer to the "Removing the faceplate" (page 12).
• After installation of your Mask unit, be sure to transmit the
Mask Key's signal to deactivate the demonstration mode.
If this procedure is not carried out, the control panel of the unit
will re-open in two seconds even with your vehicle's ignition
turned off.
• When the moving faceplate is hit by an object, it will stop and
return to its original state. Remove the object and repeat the
action.
Using the Unit in Vehicles with Covered Consoles
• Make sure the console is uncovered whilst the faceplate is
reversed.
• Do not exert any excess force on the movable parts of the unit,
including the faceplate, as it can cause failure in the unit’s
mechanism.
2CAUTION
NOTE
Power
General features
— 8 —
English
ANG
DAB
PTY
4 ¢
SRC CLK
ANG
▲ ▼
ATT / LOUD
Q
KDC-V7090R
KDC-7090R
ATT indicator Clock indicator
LOUD indicator
SYSTEM Q indicator
ATT indicator Clock indicator SYSTEM Q indicator
Speaker Setting indicator
LOUD indicator Speaker Setting indicator