Kenwood KDC-V7090R EN User Manual
Page 45
— 45 —
Troubleshooting Guide
A CD ejects as soon as it is
loaded.
The CD is upside-down.
Load the CD with the labelled side up.
The CD is quite dirty.
Clean the CD, referring to the section on "Cleaning CDs"
(see page 6).
The sound skips on a CD.
The CD is scratched or dirty.
Clean the CD, referring to the section on "Cleaning CDs"
(see page 6).
The specified track does not
play.
Random play has been selected.
Turn off the random play function.
SOLUTION
POSSIBLE CAUSE
PROBLEM
A speaker cable may be pinched by a screw in the car.
Check the speaker wiring.
No sound can be heard, or the
volume is low.
The fader and/or balance settings are set all the way to
one side.
Reset the fader and/or balance settings.
The input/output cables or wiring harness are connected
incorrectly.
Reconnect the input/output cables and/or the wiring
harness correctly. See the section on "Connecting
Cables to Terminals".
The sound quality is poor or
distorted.
The speakers are not wired correctly.
Reconnect the speaker cables so that each output
terminal is connected to a different speaker.
The Attenuator function is turned on.
Turn off the Attenuator function.
The values of Volume offset are low.
Increase the values of Volume offset. (see p. 15)
Can’t remove disc.
The cause is that more than 10 minutes has elapsed
since the vehicle ACC switch was turned OFF.
The disc can only be removed within 10 minutes of the
ACC switch being turned OFF. If more than 10 minutes
has elapsed, turn the ACC switch ON again and press
the Eject button.