Kenwood KDC-V7090R EN - Manual (Page 26)

If the disc changers that were manufactured and sold after 1997
(except for KDC-C560) are connected, you can directly input
letters using the number/letter entry buttons on the remote
control.
Example: Use the following table to enter the name "DANCE".
Continue steps 3 and 4 until all the characters are chosen for
the name.
You can enter up to 12 characters for each name.
Press either the NAME.S button on the main unit or the OK
button on the remote control.
The disc name is stored and the disc name preset mode is
cancelled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.
• The number of discs whose names can be stored will differ
depending on the disc changer that is connected. Please see
your disc changer manual for details.
Up to 30 CDs can be registered with this unit.
• Discs are identified by their total length and number of tracks. If
another disc happens to have the same specifications as one
that you have already stored a name for, the name will be
displayed for it, too.
• If you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to input the
changes.
• Pressing the reset button erases the disc names stored in this
unit, but does not erase the names stored in a disc changer.
NOTE
6
NOTE
5
Button to press # Times pressed Character
#3 1
1 #2
#6 2
#2 3
#3 2
“D”
“A”
“N”
“C”
“E”
Store the names of discs to be displayed when played.
Play the disc whose name you want to preset.
• This function is not available for disc changers that do not
feature the Disc Name Preset function.
• The disc name preset function cannot be used when the
Magazin random play and disc title or track title is displayed.
Hold down the NAME.S button for two seconds or more.
"NAME SET" is displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.
Press either the 4 or ¢ button to move the cursor to the
desired position.
The
4 button moves the cursor to the left, and the ¢
button to the right.
You can also move the cursor left or right by pressing the
4
or ¢ buttons, respectively, on the remote control.
Each time the 38 button is pressed, the characters to be
entered change as listed below.
Press the DISC
+
or DISC
–
button to display the desired
character.
Characters that can be displayed are as follows.
Direct Alphabet Input
(Function of remote control with number/letter entry buttons) NOTE
4
3
2
NOTE
1
Presetting Disc Names (DNPS)
CD/External disc control features
— 26 —
English