Konica Minolta 125 - Manual (Page 22)

41 40
The remote control uses a 3V lithium battery (CR2032).
When pressing the remote-control buttons does not release
the shutter, the battery must be replaced. (The supplied
battery should be sufficient for approximately ten years of
operation).
1. Pull out the battery chamber and remove the old
battery (D).
2. Insert a new battery into the battery chamber with
its plus side up (E).
3. Slide the battery chamber back into the remote
control.
CHANGING THE BATTERY
D
E
3. Lift your finger from the shutter-release button, then recompose
the picture.
4.Point the remote control toward the front of the camera, press
either the Release button (•) or Delay button (2s).
• The green ready lamp keeps glowing and the focus will remain locked after
taking a picture.
• Reset the remote-control mode or press the zoom button to cancel focus hold.
IR REMOTE CONTROL RC-3 ( SOLD SEPARATELY )