Kenwood KRF-V5090D - Manual (Page 18)

18 EN
ENGLISH
Listening to a source component
Normal playback
AUTO/MONO INPUT SELECTOR POWER
ON/OFF
SPEAKERS
ON/OFF
ON/STANDBY
INPUT SELECTOR
VOLUME CONTROL
Input
Selector
VOLUME %/fi
The speaker indicator lights up.
1
Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
The input sources change as shown below:
1 “TUNER”
2 “CD/DVD”
3 “TAPE” or “MD”
4 “VIDEO1”
5 “VIDEO2”
6 “DVD/6CH”
7 “AUX”
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOLUME % / fi keys to
adjust the volume.
Preparing for playback
Some preparatory steps are needed before starting playback.
Turning on this model
1 Turn on the power to the related components.
2 Turn on the power to this model by pressing POWER ON/OFF
and ON/STANDBY key.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO2,
DVD/6CH jacks, make sure that the input mode setting is correct for the
type of audio signal to be used.
7
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the
source to “MD”, follow the steps below:
1 Use the INPUT SELECTOR knob to select “TAPE”.
2 Hold down the AUTO/MONO key for more than 2 seconds.
• The source indication changes to “MD”.
• To return to the original indication, repeat procedure
2.
Setting the speaker status
Press the SPEAKERS ON/OFF key to switch the speaker on or off.
04.11.23, 13:04 18