Kenwood H2EC - Manual (Page 6)

11
• Press and Hold for about 2 seconds to go back
to a previous channel.
Remote Control
Functions
Power ( ) Key: Turns Here
2
Everywhere off and on.
Select Key: Used to select items in a list after
navigating the list with CH Up and Down Keys.
CAT (<, >) Keys: Enters Category List Mode and
moves from category to category.
CH Up and Down Keys: Moves up and down one
channel (in Channel Seek Mode), or one preset
(in Preset Seek Mode).
Mute Key: Turns off the audio of Here
2
Everywhere.
Display Key: Switches the display between different
modes with artist and song title information displayed
in various sizes.
Jump Key: “Jumps” over to a special stored channel,
such as a local traffic channel; then can be used
to “jump” back to the previous channel.
Number Keys: Numbers 1-6 select preset channels
in the currently selected band. Numbers 0-9 are
used with the Direct button to tune directly to a
specific channel number.
Direct Key: Enters Direct Tuning Mode.
Preset Key: When followed by Number Key 1-6,
stores the current channel as preset 1-6 in the
current bank.
Band Key: Cycles through the 5 banks of presets.
List Key: Enters and cycles between several list
modes: Channel, Artist, and Song Title.
P. Tune Key: Switches back and forth between
Preset Tune Mode and Channel Tune Mode.
Back Key: Return to the most recently tuned
channel (previous channel).
Memo Key: Saves song and artist information.
10
• Temporarily plug the cigarette lighter adapter
into the cigarette lighter.
• Slide Here
2
Everywhere all the way into the
cradle so that the connector at the bottom
of the unit makes proper contact in the cradle.
Press the power (
) button to turn
Here 2 Everywhere on.
Note: KENWOOD RECOMMENDS UNPLUGGING THE
CIGARETTE LIGHTER ADAPTER AFTER YOU TURN OFF
THE VEHICLE’S IGNITION. (In some vehicles, the
cigarette lighter remains active after the ignition
has been turned off, and leaving Here
2 Everywhere’s
cigarette lighter adapter plugged into the cigarette
lighter could drain the vehicle’s battery.)
• If your Here
2
Everywhere has been properly
connected and the antenna is receiving the
SIRIUS signal (Preview Channel #184), you
will hear audio. If you do not hear audio,
the display will read “Acquiring Signal.”
Front-panel Controls
and Features
Power ( ) Button: Turns Here
2
Everywhere off and on.
Memo Button: Saves and recalls song and artist
information; enters S-Seek List Mode (see pg. 18
for more on S-Seek).
Display Button: Switches the display between different
modes with artist and song title information displayed
in various sizes; also used to enter Channel List Mode.
Menu Button: Enters and exits Setup Mode.
Band Button: Cycles through the 5 banks of
presets; enters and exits the Preset Tune Mode.
Jump Button: “Jumps” over to a special stored
channel, such as a local traffic channel; then can
be used to “jump” back to the previous channel.
Cat. (<, >) Buttons: Enters Category List Mode
and moves from category to category.
Preset Number Buttons, 1-6: Sets and selects
preset channels.
Control Knob: Turn to change channels or move
around in menus.
• Press to make selections in menus and lists.
Power
Display
Memo Display Menu Band
Jump
Cat.> Cat.<
Control Knob Presets
Power
Cat.<
Ch
Mute
Number Keys
Direct
Band
Back
List
Ch
Select
Cat.>
Jump
Display
Preset
P. Tune
Memo
KEN.4064 H2EReceiver/Car Man 11/19/04 9:44 AM Page 10