Kenwood H2EC - Manual (Page 13)

25
the Time Features submenu.
Clock: Format
This option allows you to select between 12-hour
format and 24-hour format.
Clock: Time Zone
This option allows you to select one of the following
time zones:
• (GMT -9:00) Alaska
• (GMT -8:00) Pacific (Factory Default)
• (GMT -7:00) Mountain
• (GMT -6:00) Central
• (GMT -5:00) Eastern
• (GMT -4:00) Atlantic
• (GMT -3:30) Newfoundland
Clock: Daylight Savings Time
This option sets whether or not your location observes
daylight savings time (not whether DST is in effect—
this is transmitted in the SIRIUS broadcast).
Alarm Clock
This menu option allows you to set Here 2 Everywhere
to turn itself on at a selected time, or, if the unit is
already on, beep and flash the display. The last
active channel prior to shutdown will be activated
when the Alarm goes off.
The submenu below gives you two options:
• Set Alarm (or Clear Alarm, if it is already set)
• Alarm Time
Alarm Clock: Set Alarm
This option allows you to enable or disable the
alarm, itself.
Note: When the alarm function is enabled, the
clock on the default screen will be highlighted.
Alarm Clock: Alarm Time
In this mode, you can change the alarm time as
follows: Use the Control Knob (or the remote CH
buttons) to select the hour. Press the Control Knob
(or the remote Select button) to save the hour, and
move the selection to the minutes. Use the Control
Knob to select the minutes, and press the Control
Knob (or the remote Select button) to save it. Use
the Menu button to cancel changes and exit back
to the Alarm Clock submenu.
Note: If Here
2
Everywhere is off (but with power while
in the Cradle) when the Alarm time comes, it will
power itself on and present the option, “Press Band
to Snooze”. The Snooze option is a 9-minute delay
until the alarm goes off again. Also, you can press the
Power (
) button to cancel the alarm and shut
Here 2 Everywhere back off or any other key to simply
cancel the alarm and go to music.
24
screen is different in that it will stay until you press the
Control Knob, the Menu button, or the remote Select
button. This allows you to stay in this mode while you
adjust the antenna location to your satisfaction.
Memory Options
This submenu has options that allow you to turn on
or off the S-Seek feature (pop-ups to tell you that
your selected songs are playing), and to clear all
the songs stored with the Memo button.
Auto Memory Search
This is an on/off selection to enable or disable
S-Seek pop-ups and alerts. Use the Control Knob
(or the remote CH buttons) to select “On” or “Off.”
Press the Control Knob (or the remote Select
button) to accept the current setting.
Clear All Memory
This option will clear all the songs stored with the
Memo button. Use the Control Knob (or the remote
CH buttons) to select “Yes” or “No.” Selecting “Yes”
will remove all the songs stored by S-Seek, and
thereby remove all alerts.
Time Features
This menu option allows you to control the clock,
alarm, program alerts, and other features that use
Here
2
Everywhere’s internal clock.
Here
2
Everywhere has an internal clock which auto-
matically picks up Universal time from the SIRIUS
broadcast. After you set the Timezone and Daylight
Savings Time features, the clock will always keep
accurate time. However, the clock does require the
SIRIUS signal after the unit is connected to power
each time before it is valid. After you dock or power
Here
2
Everywhere, allow a few seconds to acquire
the clock signal.
The Time Features menu option presents the following
submenu choices:
• Clock
• Alarm Clock
• Program Alert
• Auto Shutdown
• Sleep Mode
Clock
Selecting this menu option allows you to setup the
clock that is shown on the default display.
The following options appear in this submenu:
• Format
• Time Zone
• Daylight Savings Time
Pressing the Select button enters the selected
submenu. Pressing the Menu button returns to
KEN.4064 H2EReceiver/Car Man 11/19/04 9:44 AM Page 24