Kenwood DNX9980HD - Manual (Page 22)

22 | Quick Start Guide
Connection
A
PRK SW
A
Installation of this unit requires skills and experience so leave the
mounting and wiring to professionals. When the unit is being
installed the wiring should be connected via the vehicles’ fuse box
ensuring the correct amperage is used. Failure to do so may result in
damage to the unit and/or the vehicle or may result in fire, etc.
Antenna Cord
FM/AM antenna input
For safety reasons, be sure to connect the parking sensor.
Light Green (Parking sensor wire)
Connect to the vehicle's parking
brake detection switch harness.
Yellow (Battery wire)
Black (Ground wire)
- (To car chassis)
Red (Ignition wire)
To steering remote
If no connections are made, do not let the cable come out from the tab.
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
Depending on what antenna you are using,
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
When using the optional power amplifier,
connect to its power control terminal.
To car light control switch
Connect to vehicle's reverse lamp harness
when using the optional rear view camera.
Ignition key
switch
ACC
Car fuse box
(Main fuse)
Battery
Car fuse box
To use the steering wheel remote control feature, you need
an exclusive remote adapter (not supplied) matched to your
car.
⁄
⁄
⁄
¤