Kenwood DNX9980HD - Manual (Page 18)

18 | Quick Start Guide
Basic Operations of Remote Control
Battery installation
Use two “AAA”/”R03”-size batteries.
Insert the batteries with the + and – poles
aligned properly, following the illustration
inside the case.
Notes
If the Remote Controller operates only over
shorter distances or does not operate at all, it is
possible that the batteries are depleted. In such
instances, replace the both batteries with new
ones.
1
2
3
4
5
6
7
8
9
0
-
=
~
!
@
DVD
T V
NAV
AUD
U
U
U
U
Remote Controller mode switch
• AUD mode: Switch to this mode when
controlling a selected source or tuner
source, etc.
• DVD mode: Switch to this mode when
playing DVDs or CDs etc. with the player
integrated in this unit.
• TV mode: Switch to this mode when
controlling TV.
• NAV mode: Switch to this mode when
controlling Navigation unit.
Notes
When controlling a player that is not integrated in
the unit, select “AUD” mode.
¤ CAUTION
• Put the Remote Controller in a place
where it will not move during braking or
other operations. A dangerous situation
could result, if the Remote Controller falls
down and gets wedged under the pedals
while driving.
• Do not leave the battery near fire or
under direct sunlight. A fire, explosion or
excessive heat generation may result.
• Do not recharge, short, break up or heat
the battery or place it in an open fire.
Such actions may cause the battery
to leak fluid. If spilled fluid comes in
contact with your eyes or on clothing,
immediately rinse with water and consult
a physician.
• Place the battery out of reach of children.
In the unlikely event that a child swallows
the battery, immediately consult a
physician.