Kenwood KDC-7080R - Manual (Page 39)

— 39 —
Refer to the section "Removing the faceplate (page 12)" and
then reattaching the faceplate.
Never insert the taptite screws (ш2
Ч
6 mm) in any other screw
holes than the one specified. If you insert it in another hole, it
will contract and may cause damage to the mechanical parts
inside the unit.
2CAUTION
3
Locking the faceplate to the unit
If you want to lock the faceplate to the unit so that it does not
fall off, follow the directions below.
Refer to the function "Removing the faceplate (page 12)" and
remove the faceplate.
Insert the provided screw into the hole at the centre of the
bottom side of the faceplate which you have removed from
the unit.
2
1
Accessory5
Locking the faceplate to the unit ■