Kenwood KDC-7080R - Manual (Page 11)

You can adjust the faceplate angle for easy viewing.
Adjusting faceplate angle:
Press the ¡ (EJECT) button to make the faceplate slide open,
and then adjust the faceplate angle using the angle adjustment
switch.
Adjustment may be made from 0 to 2.
• Firmly slide the switch until it clicks.
• Do not apply excessive force to the faceplate under settings 1
or 2.
• Set the angle adjustment switch to "0" before removing the
faceplate.
NOTE
0 1 2
0 1 2
0 2
1
Faceplate Angle Adjustment
"CALL" disappears from the display, and the volume of the
original source is restored gradually.
Turning TEL Mute Function Off After Phone Call:
Hang the phone up.
"CALL" disappears from the display.
The original source (i.e., the one used before the phone call) is
returned to automatically, and the volume restored gradually.
Shut down the audio system temporarily whenever an
incoming call is received.
The function will not work if a cable is not connected to the car
phone.
When the telephone rings:
When a call is received, "CALL" is displayed and all the unit
functions are temporarily interrupted.
Restoring Original Unit Source During Phone Call:
Press the SRC button.
NOTE
TEL Mute
You can change the display in each mode.
Changing the Display:
Each time you press the CLK button, the display switches as
follows:
The £ indicator lights whilst the clock is displayed.
NOTE
Clock
Date
Mode display
Switching Display
• When you change the setting of type of speaker, the bass and
treble tone settings are returned to original levels.
— 11 —