Kenwood KRC-X858 - Manual (Page 9)

— 9 —
This function allows you to adjust the setting that is recalled
with the sound coordinate system, according to types of
speakers.
Press the SRC button repeatedly to select the standby mode.
"ALL OFF" is displayed when the standby mode is selected.
Press the AUD button to enter the mobile preset plan mode.
Press either the 4 or ¢ button to select the type of
speaker. The setting switches as follows.
OFF / For the OEM speaker / For 6/6x9 in. speaker /
For 5/4 in. speaker
Press the AUD button to end the mobile preset plan mode.
• This mode is available only when the Sound coordinate system
is on. (page36)
• When you change the setting of type of speaker, the bass and
treble tone settings are returned to original levels.
NOTE
4
3
2
1
Mobile Preset
This mode is available only when Sound coordinate system is
on.( page36).
Function of the KRC-X858
Recalling your sound settings:
Press a preset button (#1-6) except during the bass center
frequency, bass level, bass quality factor, bass extension,
treble center frequency, and treble level adjust mode.
NOTE
Function of the KRC-X858
Storing your sound settings:
Press a preset button (#1-6) for at least two seconds.
• This setting can be made only when the Sound coordinate
system is on.( page36).
• The settings you can preset are, bass center frequency, bass
level, bass quality factor, bass extension, treble center
frequency, and treble level.
NOTE
"V OFFSET" : Set the sound level of the each source selected by
adjusting the level difference between the basic
sound level and the required level.
Setting values: - 8 – 0
Function of the KRC-X858
"NF Phase" : Adjust the phase for Non-Fading output.
Setting values: Normal (0°) / Reverse (180°)
• This mode is available only when the non-fading output function
is set to on.( page10).
• Not available during the Dual zone system is on.
NOTE
Function of the KRC-708
KRC-X858_U.S-4 00.12.27 0:12 PM Page 9