Konica Minolta 7020 - Manual (Page 24)

24 * Option
This section deals with the functions needed for simple, straight-
forward copying jobs.
Some features and functions of this system cannot be activated
simultaneously. The table after page 50 shows, which functions
are compatible.
Basic Screen
7.1 Automatic Copying
– Switch the unit on at the main switch (see also 6.1 Timer), and
wait until the system is ready. Warm-up time is approx. 30 sec.
– The display shows the Basic screen.
– If the copier is also connected as a printer
* and/or Fax * , press
the COPY key, until the basic screen appears.
– If the Electronic Key Counter (EKC) is active, enter your pass-
word and press START (see also 6.2 Electronic Key Counter).
– Insert original(s) into the RADF * , select the desired copy
quantity and press START.
– Copies exit into the Finisher * or into the exit tray inside the
unit.
Automatic Functions
These functions are active under AUTO RESET:
Automatic Paper Size Selection (APS)
– The copier automatically selects a tray with the paper size of
the original.
– The original is copied same size.
– If the corresponding paper size is not available, the image will
be rotated by 90
°
on the copy, where possible (e.g. A4 to
A4R).
– Press OUTPUT if the automatic rotation does not work.
Activate this function in the finishing screen.
– If no paper of a suitable size is available, a message will appear
on the screen to supply paper of the required size.
– APS does not work with AMS or if an individual magnification
ratio was entered.
Automatic Magnification Selection (AMS)
– If you specify a particular tray to copy from resp. a particular
paper size to copy onto, the system automatically calculates
the correct magnification ratio.
– The original is copied in the corresponding size onto the copy
paper.
– AMS does not work with APS or if an individual magnification
ratio was entered.
Automatic Exposure (AE)
– The original is scanned and exposed with a suitable density.
– For a manual darker/lighter exposure press the corresponding
arrows.
– The AUTO key on the Basic screen activates AE.
AUTO RESET
– A short time after the last copy or the last selection is made,
the system returns to the initial settings.
– The key operator can adjust the interval until Auto Reset is
performed, or switch off Auto Reset altogether.
7. Simple Copying