Konica Minolta 7020 - Manual (Page 23)

23
6. Before Copying
Auto Low Power / Auto Shut-Off
– The key operator can adjust this system, so that the unit will
automatically switch into Auto Low Power Mode after a delay
of 5 minutes or more after copying. In this mode the tempera-
ture of the fixing unit is lowered to conserve energy. After a
further delay which can be specified by the key operator, the
system goes into Auto Shut-Off mode in which the energy
consumption is further lowered.
– To switch on the unit when in one of these energy saving
modes, press any key except the Start key.
Power Saver Key
– There is a certain warm-up time, if the system is activated
again from this mode.
– To deactivate the mode, press the Power key again on the left
side of the panel.
6.3 Power Saver Mode
If the Power Saver Mode is active, the LCD
goes dark.