Kenwood KRC-709 - Manual (Page 33)

— 33 —
Removing the Unit
Removing the hard rubber frame
■
Insert the removal tool into the indentations in the hard rubber
frame, and pull it gently until the lock is released.
Accessory0
Removal tool
Accessory4
Removing the Unit
■
Push upward the removal
tool toward the top, and
pull out the unit halfway
whilst pressing towards the
inside. 4
Pull the unit all the way out
with your hands, being
careful not to drop it. 5
Be careful to avoid injury from the catch pins on the removal
tool.
2CAUTION
Catch facing up
Refer to the section “Removing the hard rubber frame” and
then remove the hard rubber frame.
Remove the Hex-head screw with integral washer (M4 ×8) on
the back panel.
Insert the two removal tools deeply into the slots on each
side, as shown. 3
2
1
Accessory3
Removal tool
KRC-709_U.S_m2 00.12.26 3:30 PM Page 33