Karcher SHD-R 3000 - Manual (Page 21)

English SHD-R 3000
5.956-486 A2005937 (06/03) E5
E. Care and maintenance
V-belt
Test tension of V-belt and adjust as follows:
„
Switch off system, and ensure that it
cannot be switched back on again
unintentionally.
„ Remove guard over V-belt.
„ Test belt tension.
Press down on belt which should not
move by more than 1 cm. If necessary,
adjust as follows:
„ Slacken off mounting bolts (1).
„ Tension V-belt by adjusting bolts (2).
„ Ensure that V-belt runs in a straight line.
„ Tighten mounting bolts (1).
„ Refit belt guard.
Replacing the V-belt:
„ Switch off system, and ensure that it
cannot be switched back on again uninten-
tionally.
„ Remove guard over V-belt.
„ Slacken off mounting bolts (1).
„ Unscrew bolts (2) fully, and push motor
towards pump.
„ Replace V-belt.
„ Tension belt by adjusting bolts (2).
„ Ensure that V-belt runs in a straight line.
„
Tighten mounting bolts (1).
„
Refit belt guard.