KORG C-320 User Manual
Page 37
Assembling the stand
35
NB: You will need a cross-point (Phillips #2) screwdriver for assembly.
2
Screw the adjuster into the pedal box as far as it will go, and attach the pedal
cable.Use screws (a) to fasten the side panels to the pedal box. Make sure that there
is no gap between the side panels and the pedal box.
Assembly Accessories
Screws (b)
(M4 x 14)...6pcs.
Piano Fasteners
...2 pcs.
Adjuster...1pc.
Screws (a)
(M6 x 20)...4pes.
Cable holder
...2 pcs.
Caps...4pcs.
This is used to adjust the height
after you’ve finished assembling
the stand; don’t tighten it completely.
Screws (a)
Pull out the
pedal cable
Align precisely, so that there is
no gap between the side panel
and pedal box.
See also other documents in the category KORG Musical Instruments:
- K61 (73 pages)
- GT-4 (2 pages)
- ESX-1 (108 pages)
- Ax3000b (68 pages)
- GT-120 (1 page)
- D1200 (8 pages)
- TP-2 (4 pages)
- BA-40 (2 pages)
- SP 250 (51 pages)
- SP 250 (184 pages)
- D12 (2 pages)
- AX10g (2 pages)
- D1200mkii (8 pages)
- CX-3 (40 pages)
- C-520 (298 pages)
- MS2000 (6 pages)
- M3 (32 pages)
- M3 (237 pages)
- OASYS musical instruments (241 pages)
- EASYSTART AX3B (3 pages)
- AX10A (39 pages)
- KONTROL49 (4 pages)
- TRITON Extreme music workstation/sampler (148 pages)
- Pa800 (9 pages)
- EMX-1 (99 pages)
- TRITON STUDIO music workstation (305 pages)
- microX (134 pages)
- TouchView Trinity (160 pages)
- Ax3000g (67 pages)
- Electribe EM-1 (56 pages)
- METROGNOME MM-1 (2 pages)
- Kaossilator Dynamic Phrase Synthesizer (4 pages)
- Kp3 (6 pages)
- D8 (76 pages)
- sampler (167 pages)
- KPC-1 EFG (95 pages)
- AX10B (40 pages)
- TRITON Musical Instrument (91 pages)
- D3200 (200 pages)
- X50 (132 pages)
- KM-2 (35 pages)
- PXR4 (99 pages)
- DT-10 (3 pages)
- D888 (52 pages)