Kodak EKTACOLOR PRIME LORR CIS-267E - Manual

 Eastman Kodak Company, 2006
CURRENT INFORMATION SUMMARY
July 2006
•
CIS-267E
Using KODAK Chemicals with
KONICA 8xx series and R1 & R2
Minilabs
The processing chemicals that you use in a particular
minilab system depend on the type of processor the system
incorporates and its process cycle. This publication
describes the use of KODAK EKTACOLOR PRIME LORR
Chemicals to process KODAK EKTACOLOR EDGE and
ROYAL Digital Color Papers in the KONICA 8xx series
and R1& R2 Minilabs that are compatible with the
Konica CPK-2-22 LR (SQA) process designation.
Other publications are available on the Kodak website
at www.Kodak.com/go/photochemicals; select the link for
“Processing Manuals.” Current versions of Current
Information Summaries are available at the link for
“Technical Information.”
RECOMMENDED KODAK CHEMICALS
You may use KODAK Chemicals for the KONICA 8xx
series and related Minilabs, using these instructions. They
offer convenience, cost savings, and a minimum of solution
waste. KODAK EKTACOLOR PRIME SP Developer
Replenisher LORR offers the advantages of a single-part
concentrate for convenient handling and a low
replenishment rate. In addition to the developer, you will
need KODAK EKTACOLOR PRIME SP Bleach-Fix
Replenisher LORR. You will also need KODAK
EKTACOLOR PRIME Stabilizer and Replenisher LORR.
ORDERING KODAK EKTACOLOR PRIME
LORR CHEMICALS
KODAK EKTACOLOR PRIME LORR Chemicals are
available in convenient mix sizes. The catalog numbers in
the following Table 1 are for Europe and the Middle East
Region. The table shows the product details and the number
of 10.2 x 15.2 cm (4 x 6-inch) prints that can be processed
per unit (to-make 10 litres).
Table 1 Processing Capacities
KODAK Chemical
& make size
CAT No.
10x15cm
Prints per 10L
KODAK
EKTACOLOR
PRIME SP
Developer
Replenisher LORR
4x 10L
527 0996 5446
KODAK
EKTACOLOR
PRIME SP Bleach-
Fix Replenisher
LORR 2x 10L
528 8105 8714
KODAK
EKTACOLOR
PRIME Stabilizer
and Replenisher
LORR 10x 10L
527 0863 1662*
* This is the capacity for processors with three stabilizer tanks. If
the processor has four stabilizer tanks, the capacity is
approximately 3324.
You will need to mix developer, bleach-fix and
stabilizer replenisher solutions for these chemicals. The
processor automatically determines the amount of paper
processed and delivers the necessary amounts of the
replenishers to the processor tanks.