KVH Industries TracVision G4 - Manual (Page 50)

Installation
54-0147 45
Installing Your Selected Satellites
To install your selected satellites as Satellite A and B, follow the
steps below.
1. Apply power to the ADCU.
2. Following the startup sequence, press the center
button until the “Control Antenna?” screen
appears.
3. Press the ENTER button to access the Control
Antenna Mode.
4. Press the center button until the “Install Satellite?”
screen appears.
5. Follow the process shown in Figure 2-35 on the
following page to install your selected satellites. At
the end of the process, be sure to press the YES
button to restart the antenna.
Control antenna?
Enter Next Return
Install satellite?
Yes Next Return
Section 3, “Using the ADCU
Interface” on page 59
provides
complete details on the use of the
ADCU menus, including complete
antenna control details in
Section 3.8, “Control Antenna
Mode” on page 81.
Figure 2-33
Control Antenna Screen
Figure 2-34
Install Satellite Screen